I have a 8x8 tent up and it’s showing about 50 degrees in there, how can I heat it up some?
2 Likes
you can wrap something around the roots zones. kinda like putting sweaters on them…
1 Like
I was thinking maybe a portable heater
1 Like
Are you exhausting air? Can you slow it to create more heat. Or put more of the existing equipment inside to create more heat? Turn up the light, block vents a little.
1 Like
lol i thought you might not have had power.
3 Likes
There actually might be vents i can close, I am exhausting with slower speed, but i do only have one out of the two lights on.
2nd… bro how are you doing!!! Glad to see you alive man!
1 Like
Naw i got power lol. I should’ve maybe said that lol
1 Like
Doing well man. Got the last 2 pins out of my wrist. Heading back to work in 13 days! Been driving all over. working in the garden it hurts but im getting better and better slowly. Rehab is painful AF! But thanks for checking in on me. Hows your side. family good?
2 Likes
3 Likes
Great to hear man!! Glad your getting better!!
Yeah the family’s good this way!! Getting ready to pick up these clones and get it POPPIN!!!
2 Likes
So funny thing is… i have this lmao.
1 Like
Yeah we know @poppa but there like $150.00
Ill just use my inkbird humidity controller its far cheaper. But i would like an infinity fan. Are you getting one @poppa?
2 Likes
I have one!
3 Likes
Man lucky you!
2 Likes
I got me one of them, had it about two years now. The thing about it is if you set the humidity at a point, it will come on regardless of the temp and visa versa. So it is really only good for one or the other. If you want the tent to warm up to say 78, and you want the humidity at 50% if the humidity gets 51% it will come on and there goes your heat if it isn’t up to 78. So it is a much needed improvement over the old on or off exhaust fans…but it has it’s limitations. The only real way to control both is to have something that adds humidity if you need it with a separate controller. And the fan only comes on when the heat exceeds the setting. It doesn’t have exception to a major rule programming.
1 Like
Yeah but I’ve yet to figure it out tho lol.
2 Likes
Right, i never see the fan actually adjust on it’s on.
2 Likes
I got fan speed controllers. And temp on off swirltches. Then the humidifier and the fan are plugged into the inkbird. I had to wire up a y plug so i could pkug them both into 1 controller.
3 Likes
In order to not have the fan come on with humidity you have to turn it off by going to the humidity low/high on the menu and then dropping the fan speed to 0. then the fan will not react to humidity settings. then go to heat high setting and turn the fan up to 6. It will then come on high heat only and start at the high speed setting of 6 and then gradually drop down in speed till the setting is reached then shut off. HTH Same for humidity, just reverse the settings.
4 Likes
Bruh… THANK YOU! Was looking for instructions like these for the longest!
3 Likes